RS232-MUX

#

# Generated Makefile - do not edit!

#

# Edit the Makefile in the project folder instead (../Makefile). Each target

# has a pre- and a post- target defined where you can add customization code.

#

# This makefile implements macros and targets common to all configurations.

#

# NOCDDL

# Building and Cleaning subprojects are done by default, but can be controlled with the SUB

# macro. If SUB=no, subprojects will not be built or cleaned. The following macro

# statements set BUILD_SUB-CONF and CLEAN_SUB-CONF to .build-reqprojects-conf

# and .clean-reqprojects-conf unless SUB has the value 'no'

SUB_no=NO

SUBPROJECTS=${SUB_${SUB}}

BUILD_SUBPROJECTS_=.build-subprojects

BUILD_SUBPROJECTS_NO=

BUILD_SUBPROJECTS=${BUILD_SUBPROJECTS_${SUBPROJECTS}}

CLEAN_SUBPROJECTS_=.clean-subprojects

CLEAN_SUBPROJECTS_NO=

CLEAN_SUBPROJECTS=${CLEAN_SUBPROJECTS_${SUBPROJECTS}}

# Project Name

PROJECTNAME=RS232_MUX.X

# Active Configuration

DEFAULTCONF=default

CONF=${DEFAULTCONF}

# All Configurations

ALLCONFS=default 

# build

.build-impl: .build-pre

	${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .build-conf

# clean

.clean-impl: .clean-pre

	${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .clean-conf

# clobber

.clobber-impl: .clobber-pre .depcheck-impl

	    ${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default clean

# all

.all-impl: .all-pre .depcheck-impl

	    ${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default build

# dependency checking support

.depcheck-impl:

#	@echo "# This code depends on make tool being used" >.dep.inc

#	@if [ -n "${MAKE_VERSION}" ]; then \

#	    echo "DEPFILES=\$$(wildcard \$$(addsuffix .d, \$${OBJECTFILES}))" >>.dep.inc; \

#	    echo "ifneq (\$${DEPFILES},)" >>.dep.inc; \

#	    echo "include \$${DEPFILES}" >>.dep.inc; \

#	    echo "endif" >>.dep.inc; \

#	else \

#	    echo ".KEEP_STATE:" >>.dep.inc; \

#	    echo ".KEEP_STATE_FILE:.make.state.\$${CONF}" >>.dep.inc; \

#	fi